I put together a 338 Sherman on a TL Hunter action with a Brux barrel. I have resized the brass and seated the bullets way out to crush them into the lands to fire form the brass. Had good resistance closing the bolt so I know they're into the lands. Problem is when i pull trigger, nothing happens. Just a click and a small dent in the primer. Has happened on 4 different rounds. Same primers were used on a different round and they fired, so assuming I didn't get 4 dead primers out of about 60 on these.
I'm thinking next step is to check firing pin protrusion? Anyone have experience with this action and could assist on how to disassemble and measure? Or any other things I can try?
Thanks!!!!
I'm thinking next step is to check firing pin protrusion? Anyone have experience with this action and could assist on how to disassemble and measure? Or any other things I can try?
Thanks!!!!