I have RA. I use a Forster trimmer with a neck turning attachment. Does a fantastic job and I can run through 100 cases in nothing flat without pain. Doing the primer pockets and flash holes is another story though.
Been using K&M for many years with zero problems running tight neck and no turn neck chamber reamers. I try turning for no more than .004/.005" clearance.
I just started to neck turn after avoiding it for years. Bought a PMA set up. So easy to set up and use. I use a small battery powered handheld screwdriver with their case holder. Perfect speed...
Ok guys, thanks for all the input, have another question. I shoot a 22-250 with neck angle of 28* What cutter angel do I
want. Do not see a cutter with that angle.
The cutter doesn't need to match. They never do. You run it just into the shoulder just a little to prevent the dreaded donut. Not much, just a little, maybe a couple of thousands at the most. I'm sure there is a figural amount but I've always just winged it