Load data for 6.5/25WSSM

Discussion in 'Reloading' started by dwm, Mar 29, 2008.

  1. dwm

    dwm Well-Known Member

    Messages:
    739
    Joined:
    Feb 26, 2003
    Barrel is on order and I have some cases prep'd.

    I am going to start with 130 Accubonds and 140 Berger VLDs.

    Any suggestion on how much H4350 I should start with?

    Thanks,

    Doug
     
  2. Mikecr

    Mikecr Well-Known Member

    Messages:
    4,262
    Joined:
    Aug 10, 2003
    I shoot 139Lapuas, and have 130Normas to try one of these days.
    I use 47.4IMR 4350(which is not the same as H4350).

    I believe 260 loads would be closest to reference, as the case capacity is pretty close.
     

  3. winmagman

    winmagman Well-Known Member

    Messages:
    1,379
    Joined:
    Mar 13, 2003
    That's good advice, I started there when I was working up loads for mine. I'm not using H4350, probably should be as I think the Re 22 I'm using is a tad to slow.

    Chris
     
  4. dwm

    dwm Well-Known Member

    Messages:
    739
    Joined:
    Feb 26, 2003
    Thanks,

    Would H4831SC would be a better choice?

    I have some of that too ...
     
  5. winmagman

    winmagman Well-Known Member

    Messages:
    1,379
    Joined:
    Mar 13, 2003
    If I were starting over again I'd go with the H4350. Not that the 4831 won't work (I have some just haven't tried it since its fairly close to Re 22) but I think a little quicker burn rate would be better. Just my unproven opinion though.

    Chris
     
  6. RockZ

    RockZ Well-Known Member

    Messages:
    899
    Joined:
    Mar 10, 2006
    I am using 130VLD's and H4350.

    My most accurate load is: 45.9gr@2.642OAL no pressure signs at all.