Jewell HVR Trigger for Win 70

Discussion in 'Gunsmithing' started by Sendero_Man, Jun 24, 2007.

  1. Sendero_Man

    Sendero_Man <strong>SPONSOR</strong>

    Messages:
    1,706
    Joined:
    Feb 4, 2007
    Hey guys,

    I installed my own Jewell in my 700 Rem. with no problems at all.

    How hard is it to put one in a Win. 70 ? I am gonna get one to put in the 243 Ackley that I just bought on here from LiteTac.

    http://longrangehunting.com/ubbthreads/s...p;page=0#158884

    Thanks for the help...

    Scott
     
  2. Sendero_Man

    Sendero_Man <strong>SPONSOR</strong>

    Messages:
    1,706
    Joined:
    Feb 4, 2007
    Anybody at all have any experience ?? /ubbthreads/images/graemlins/confused.gif
     

  3. Sendero_Man

    Sendero_Man <strong>SPONSOR</strong>

    Messages:
    1,706
    Joined:
    Feb 4, 2007
    NO ONE ????

    /ubbthreads/images/graemlins/crazy.gif
     
  4. Sam11

    Sam11 Active Member

    Messages:
    35
    Joined:
    Jan 13, 2005
    Hello: My friend installed one and he had one problem with the install but I can't remember what it was. Otherwise it was no problem. I will e-mail him and see if he would pass on what he knows. Sam.
     
  5. gunnermhr

    gunnermhr Member

    Messages:
    15
    Joined:
    Dec 28, 2004
    It's not that bad of a job. You'll need to open up the stock so your trigger assemble will fit in. A dremmel tool works good. Other than that it's plug and play.

    Mike
     
  6. Sendero_Man

    Sendero_Man <strong>SPONSOR</strong>

    Messages:
    1,706
    Joined:
    Feb 4, 2007
    It has a HS stock on it... how hard to remove alum. area ?

    got factory trigger to 3 lbs...

    thanks...
     
  7. Wild_Bill

    Wild_Bill Well-Known Member

    Messages:
    744
    Joined:
    Sep 15, 2005
    Stock Mods

    Hi the alloy machines out fairly well as already mentioned the stock needs releaving for the trigger to clear but after it is done you are good to go.

    Cheers Bill
    Australia
     
  8. CatShooter

    CatShooter Well-Known Member

    Messages:
    1,053
    Joined:
    May 8, 2001
    I have installed three.

    You will have to cut out some space in the front of the trigger guard to clear the Jewell trigger housing, and a little space in the back of the guard to clear the trigger itself.

    IT is easy - I used a Dremel tool and did it a bit at a time, until it cleared.

    They work great!!

    .