Home made handgun rear monopod

RioHondoHank

Well-Known Member
Joined
Oct 10, 2010
Messages
79
At 72 yrs old I am not a steady as I was once was, so I built this out of some 1/2 inch PVC, 1/2 inch all thread, three 1/2 nuts, three 1/2 slip on PVC caps and one sawed in two 1/2 inch male threaded PVC plug. For now the male plug is wrapped in tape for a snug fit. I will replace that with some 1 inch shrink tubing as soon as I pick some up. The 1/2 inch nut fits snug within the PVC slip on cap at the top and only requires to be pushed in place and the cap still can be glued to the tube.

Hope to test on some yotes this evening.

65322bf9.jpg


b26a6628.jpg


40c27afb.jpg
 
Warning! This thread is more than 13 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top