G
Guest
Guest
What do you think of the extractor system on the Pro Series 2000?
Who owns one of these or has access to one who can do some very accurate measurements so a person could install those extractors on other bolts? I have some of the extractors (H-S will sell them as parts), but they won't provide installation instructions for various reasons. I would need to know:
Depth of hole
Size of elliptical hole (both dimensions) - also, is it elliptical the full depth?
Hole offset from centerline on standard and magnum bolt faces
Location in lug in relation to plunger ejector in degrees
Location of cross pin
If anyone can assist me, I would appreciate it much.
[email protected]
[ 03-23-2004: Message edited by: TBerkhouse ]
Who owns one of these or has access to one who can do some very accurate measurements so a person could install those extractors on other bolts? I have some of the extractors (H-S will sell them as parts), but they won't provide installation instructions for various reasons. I would need to know:
Depth of hole
Size of elliptical hole (both dimensions) - also, is it elliptical the full depth?
Hole offset from centerline on standard and magnum bolt faces
Location in lug in relation to plunger ejector in degrees
Location of cross pin
If anyone can assist me, I would appreciate it much.
[email protected]
[ 03-23-2004: Message edited by: TBerkhouse ]
