H-S Precision actions and extractors

Discussion in 'General Discussion' started by Guest, Mar 23, 2004.

  1. Guest

    Guest Guest

    What do you think of the extractor system on the Pro Series 2000?

    Who owns one of these or has access to one who can do some very accurate measurements so a person could install those extractors on other bolts? I have some of the extractors (H-S will sell them as parts), but they won't provide installation instructions for various reasons. I would need to know:

    Depth of hole
    Size of elliptical hole (both dimensions) - also, is it elliptical the full depth?
    Hole offset from centerline on standard and magnum bolt faces
    Location in lug in relation to plunger ejector in degrees
    Location of cross pin


    If anyone can assist me, I would appreciate it much.

    terry.berkhouse@umontana.edu

    [ 03-23-2004: Message edited by: TBerkhouse ]