Coyote shotgun ammo and choke test

I have an opportunity to hunt in Texas where you can use Buckshot. So please give me some help. What factory Buckshot and choke diameter should I use? Thanks.
 
howdy, do u have 2 3/4 or 3" shotgun? in 3" I prefer Sellier & Bellot 3"shell

12ga. 15 00 buckshot in one shell. this stuff is good for deer and coyote

I also use Federal 3" 12ga. # 4 buckshot 41 pellets per shell

I use the coyote choke from predator quest or a Carlson choke. both r .560 r

less in diameter. the smaller the choke dia. the tighter the pattern.

the choke I use is good to 75yrds. never shot one further.
 
Versa Max 3.5 so I can shoot whatever ya'll have had the best luck with. I hate to go buy every brand and size of Factory Buckshot to test. Therefore, I appreciate each of you and your opinion and experience. Please keep them coming.
 
I got several boxes of Remington 3.5" 00BK. Here's the results at 50 and 70 yards.
50 yards-- Choke Mod .715 - 8 hits in 10" circle
13 hits on whole poster board
Choke Full .695 - 9 hits in 10" circle
13 hits on whole poster board
70 yards-- Choke Full .695 - 3 hits in 10" circle
8 hits on whole poster board
 
Real time results for the a fore mentioned 00 Buck. I was hunting an opening with heavy cover all around. I called a coyote in that hung up at 60 yards. I took the standing shoot. He spun circling and biting at his side. He then disappeared in the cover. Waited two hours and then went looking for him without any luck. I am sure he is dead,however, I hate wounding anything. I am changing my real life range expectations. Fifty yards for the 00 Buck. Thirty yards for the T and BB shot.
 
I found 3" to pattern better than 3.5".

I much prefer #4 buck to the larger shot.

Always shoot for the front 1/3 of a coyote with a shotgun

60 yds is pushing the outer limits for any shell/shot combo no matter what you read.
 
I remember a similar experience I had on a red fox using a 20 gauge with 3-buck many years ago. Fox was about 40 yds away. I hit him with at least one pellet every shot i fired, based on his reactions. It required 4 shots to finally get a pellet into a lethal location. What I learned from that experience is that where the individual pellets of buckshot strike is a matter of chance. I think my shells contained 21 pellets of 3-buck. Enough to hit the fox somewhere every shot, but not a dense enough pattern at that distance to ensure one would hit a vital organ.
 
I thought I did everything right by patterning. It just was not the same in real life. My real world experience was the same as yours and I am with you. I do not want to be rolling the dice. Appreciate your thoughts.
 
Even when you have a proven coyote killing shotgun load it is pretty easy to NOT center the pattern on the coyote so be ready to shoot the coyote again if it is still moving.

When I first started calling coyotes and was shooting them with a shotgun I used 3" 12 ga goose loads that I had.

I had Federal Premium 3" 1-7/8 oz loads of copper coated lead #2 and size BB. It didn't take long to see that the copper coated lead #2 shot did NOT work nearly as good as the copper coated lead BBs did on the coyotes. If the coyotes were not facing me the lead #2 shot was not big enough or heavy to penetrate deep and or break bones nearly as good as the copper coated lead BB shot did.

I don't shoot at coyotes over 40 yards away very often so I like the Federal 1-7/8 oz load of copper coated BB loads with 98 pellets per shell over the 3" number 4 buck shot loads with only 41 pellets per shell.

Now I live and hunt in an area where I have to use lead free shot to hunt coyotes. The denser than lead loads that are 12g/cc like Winchester Xtended Range, Remington Wingmaster HD and Hevi-Shot Goose loads in size #2 and bigger are very good coyote loads. All of these types of shot are denser than lead and much harder than lead so they don't slow down as fast as lead, they break bones better than lead and penetrate much deeper than lead. So the denser than lead 12g/cc #2 shot actually works pretty good on coyotes. But I prefer size BB in the 12g/cc denser than lead shot.

I have dropped many coyotes running away from me at 40 yards with Remington Wingmaster HD BB shot, it really breaks them down. They may need to be shot again but they don't get away. I want big enough and heavy enough shot to drop a coyote between 40 and 50 yards no matter what the shot angle is.

A good pattern doesn't do any good if the shot is not, heavy enough and hard enough to penetrate deep and break bones. I don't want to use a coyote shotgun load that requires head shots, coyotes are not turkeys.

The Federal Heavyweight Coyote loads have 15g/cc BB shot in them. The 12g/cc shot is 10% denser than lead, the Federal Heavyweight shot is 35% denser than lead so it out performs Hevi-Shot Dead Coyote T shot by quite a bit at longer ranges. The 3" Federal Heavyweight BB loads have 12 more pellets per shell than the Hevi-Shot 3" T shot loads have. Both of these loads are pretty expensive but I would go with the Federal Coyote BB load because of the 12 more pellets and denser shot.

Federal no longer makes the Federal Heavyweight #2 shot waterfowl loads but if you can find any they work great on coyotes.

I bought 5 cases of the Federal Heavyweight 3" 1450 fps #2 shot 1-1/4 oz loads when they were being closed out. I took the shot out of all of them and reloaded 3" 1-1/2 oz loads with the Federal Heavyweight #2 shot in them. Each shell has 90 pellets in them and they are devastating on coyotes.

I just ran some loads in my Shotgun Shell Ballistic calculator. These numbers are pretty crazy on the denser than lead shot especially the Heavyweight 15g/cc shot.


All of these loads are at 1300 fps and I had 3" of gel penetration entered. They say 2.50" of gel penetration is needed for geese.

I am not saying 3.0" of gel penetration is good enough for coyotes but these numbers will really show the differences in penetration in the shot sizes and the pellet densities.

#4 lead shot at 1300 fps got 3.0 " of gel penetration at 20.7 yards
#4 WIN XR 12g/cc shot at 1300 fps got 3.0 " of gel penetration at 31.2 yards

#2 WIN XR 12g/cc shot at 1300 fps got 3.16 " of gel penetration at 47.7 yards

BB shot Rem HD 12g/cc shot at 1300 fps got 3.26 " of gel penetration at 80 yards

#2 Fed HW 15g/cc shot at 1300 fps got 3.26 " of gel penetration at 88.7 yards

BB shot Fed HW 15g/cc shot at 1300 fps got 3.26 " of gel penetration at 137.9 yards

Look at the differences in the 12g/cc loads of BB, #2 and #4 shot.

Its to bad Federal didn't make a Heavyweight Coyote load with #1 or #2 shot!
 
Good information. That 15g/cc BB sized shot looks hell's fury. Big difference between the #2 and BB shot. 2s for geese. BBs for coyote.
 
If you find any denser than lead #2 shot at a decent price, buy it because it will work on coyotes.

12g/cc is 10% denser than lead, Federal Heavyweight is 15g/cc and is 35% denser than lead.

Especially the Federal Heavyweight 1-1/4 oz 3" 1450 fps #2 shot loads. They have 78 pellets in each shell and they will smoke coyotes way out there.

Do not buy Federal High Density loads, they are not as dense as lead. Federal Heavyweight is the bad ***** stuff.
 
Got some Winchester 3.5" #4 Buckshot to try just in case I got to go to Texas again. I tried Remington, Carlson, and High flyer chokes from modified to extra full. What worked best was the Carlson .695 with 5 hits on the 10 " circle and 14 on the poster board. These just did not improve on the BB or 00 Buck I tried earlier.
 
Warning! This thread is more than 7 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top