annealing necks, 30-378 need holder/drill

thethirdpig

Active Member
Joined
Feb 19, 2012
Messages
26
I anneal my necks using a tempestick, propane torch and turning them in my battery powered 1/2" drill. the 30 378 is too big for the chuck. Can any one suggest a case holder that will hold the brass and go into my drill?
 
Third, for my 30/378 brass I use a 3/8 extension with a deep socket just large enough to fit the case. This leaves only the top of shoulder and neck open to the flame. Good luck
 
Warning! This thread is more than 10 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts

Top