.338 Edge from 7mmRUM brass?

Hicks

Well-Known Member
Joined
Sep 19, 2007
Messages
402
Location
Windsor, CO. USA
For those of you who have one, is it possible to form .338-.300 brass from 7mmRUM brass? I've got about 200 pieces and I'd sure hate to waste them.

Hicks
 
yeah it can be done. i did exactly that making a couple dummy rounds for guys. i'd push it out in at least 2 steps, 3 would be better. then check your OAL, concentricity and wall thickness of your necks. the neck thickness doesn't change that much.
 
Warning! This thread is more than 14 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top