Tiff
Active Member
I need a bit of help sourcing the dies for necking down .338 Lapua case necks to .30cal.
I've been following the guide on 6mmbr Loading for the 30-338 Lapua
It's the Hornady die in step one that I'm confued over...Is it this die without the expander mandrel in?
https://www.hornady.com/shop/?ps_se...&category_id=c4974e36c05dcb29ab4734f31a7c6693
Any help greatly appreciated.
Cheers Tiff
https://www.hornady.com/shop/?ps_se...&category_id=c4974e36c05dcb29ab4734f31a7c6693
I've been following the guide on 6mmbr Loading for the 30-338 Lapua
It's the Hornady die in step one that I'm confued over...Is it this die without the expander mandrel in?
https://www.hornady.com/shop/?ps_se...&category_id=c4974e36c05dcb29ab4734f31a7c6693
Any help greatly appreciated.
Cheers Tiff
https://www.hornady.com/shop/?ps_se...&category_id=c4974e36c05dcb29ab4734f31a7c6693