It ain't going to fit

summitsitter

Well-Known Member
Joined
Jan 31, 2008
Messages
186
I am reloading some 270win. with h1000. Starting load is a believe 61gr. and max load is 64 gr. both being compressed. The max load will not fit into the case. I'd haven't measured it but I believe only about 62-62.5grs. will fit. Is the manual wrong or what.
 
I am reloading some 270win. with h1000. Starting load is a believe 61gr. and max load is 64 gr. both being compressed. The max load will not fit into the case. I'd haven't measured it but I believe only about 62-62.5grs. will fit. Is the manual wrong or what.


What manual, what bullet weight?

H1000 is a slow powder and is an unsung hero to the 270. I used a lot of it under a 140 Btip for Kansas whitetails. It was a very accurate, repeatable load.
 
Lee reloading manual 130gr hornady SSTs I may a little off on the weights as I don't have them here in front of me at work but I know whatever the max was will not fit.
 
"I'd haven't measured it but I believe only about 62-62.5grs. will fit. Is the manual wrong or what."

For your case, it's "wrong", your case is different from what their's was.

That's part of why they tell us not to go directly to any listed max load, our components and firearms are different from theirs, we are to start low and only go higher IF conditions allow it. Accepting that is part of the reloading learning curve.
 
Hodgdon website has 61-64gr also.

If I recall, I was in the 62.0 gr load or close with the 140 Btip. I had to tap the case with a screwdriver to settle the powder before seating the bullet.
 
with a drop tube and slow pour you should be able to squeeze it in there. just because you can get it all in there doesn't mean you should. start lower and work your way up. I have had very good luck with compressed loads.
 
I started loading at 61 grains and was going to work my way up but seen that 64 wasn't going to work. If 62 is all I can fit then that isn't very much room to adjust my load with.. I'll shoot them and see what happens. May go with a heavier bullet or different powder depending on groups.
 
Personally, I'd stick with the following powders for the 130 bullet:

7828
Re22
Re19
4350
4831
N160
N560
N165
 
Warning! This thread is more than 16 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top