Wile E Coyote
Well-Known Member
What is the load that shot this group? 'Cause when my 260 comes back from the smith, this wouldn't be a bad place to start.
Pete
New 260 Remington build..
- Thread starter danny911
- Start date
Help Support Long Range Hunting Forum
What is the load that shot this group? 'Cause when my 260 comes back from the smith, this wouldn't be a bad place to start.
Pete
SavageShtr
Well-Known Member
Here's my data so far on the Varget. Tad over 12 deviation on 38 grains.
What app did you use for this?
MudRunner2005
Well-Known Member
Does it cost money, or is it free?
https://itunes.apple.com/us/app/chronograph-log/id848380910?mt=8
4 dollars isn't bad. Has a backup option. I like it to keep things organized.
4 dollars isn't bad. Has a backup option. I like it to keep things organized.
Wile E Coyote
Well-Known Member
Good info for consideration. Thank you!
Pete
Pete
Well I have some Danny issues going on. The last thing I did to my gun prior to groups going South was added the cheek rest. I am getting lots of horizontal strings. If the stars line up it should be a good group. The one high shot was a fouling shot on a cold clean bore. I am going to the sporting goods store and buy a nice rest and bags for rear. I removed the cheek rest. I pulled the scope off. The base is rock solid. Rings and base are tight. It's good. So either my scope is acting up or it's me. I am putting the blame on me. If it's the scope it's a Vortex. They will take care of me.
WildRose
Well-Known Member
That looks to me like you aren't keeping your cheek weld consistent and/or "pushing it" a bit out of frustration.
I'm not going to write off your suggestion. You may be very accurate in your observation. I think that works out to be about 3/4 inch. I picked up some Sweet 7.62 or whatever it's called. Thinking maybe the Butch isn't cutting it. I'm cleaning it this evening. I am going to start with 38gr of Varget and 2.24" and go up and down .003" until I hit a sweet spot. 38 isn't pushing it super fast but I will take accuracy over speed.
I picked up a box of Sierra 140 Spitzer Boat Tails and may try those out. I have about 115 down the tube now and I'm getting nervous that I'm struggling. I never had cheek weld issues before but anything is possible.
I picked up a box of Sierra 140 Spitzer Boat Tails and may try those out. I have about 115 down the tube now and I'm getting nervous that I'm struggling. I never had cheek weld issues before but anything is possible.
WildRose
Well-Known Member
For myself I've found that when I'm inconsistently off like you were there it's usually me. You have two in one hole in the center, one left, one right about equidistant. That for me almost always is the result of an error from behind the gun rather than with the gun.
If your reticle were loose then it should be bounding around all over the place.
I had two vortex vipers that produced generally circular patterns for that reason. Inconsistent changes from dialing told me where the problem was. Sometimes 3 clicks was .9 MOA and sometimes it would be 2-3 MOA.
Yes they fixed them and turn around time was minimal but that's why I quit buying them. since 3 of the four I'd bought all had such problems.
