Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Water soluble case lube problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="specweldtom" data-source="post: 201795" data-attributes="member: 2580"><p>I like this stuff because of the water clean-up, but have occasionally had problems resizing .30 x .378 and .338 x .378. The radiused shoulder would push back just enough to see, but not collapse. I just figured that the double radius wasn't very strong in compression. Recently though, I resized some .30-06 cases that had been fired in a very large chamber. They literally locked up in the die about 1/2" short of where they needed to go. (body bound). I was using the Hornady spray-on lube. Just as a check, I tried some RCBS water soluble lube and they went in (and out) of the die with little more than normal force. I don't even have any of the non-water soluble anymore, but am going to get some to try again. I have been using the Hornady water soluble for years, but this is the first time that I have sized something that really loaded the press, and it wouldn't do it. </p><p></p><p>Brass fired in good chambers doesn't take much to resize, but if you're using this stuff and have some unexplained problems, try something else as a test.</p><p></p><p>I could be on the wrong track, but I don't think so.</p><p></p><p>Good shooting, Tom</p></blockquote><p></p>
[QUOTE="specweldtom, post: 201795, member: 2580"] I like this stuff because of the water clean-up, but have occasionally had problems resizing .30 x .378 and .338 x .378. The radiused shoulder would push back just enough to see, but not collapse. I just figured that the double radius wasn't very strong in compression. Recently though, I resized some .30-06 cases that had been fired in a very large chamber. They literally locked up in the die about 1/2" short of where they needed to go. (body bound). I was using the Hornady spray-on lube. Just as a check, I tried some RCBS water soluble lube and they went in (and out) of the die with little more than normal force. I don't even have any of the non-water soluble anymore, but am going to get some to try again. I have been using the Hornady water soluble for years, but this is the first time that I have sized something that really loaded the press, and it wouldn't do it. Brass fired in good chambers doesn't take much to resize, but if you're using this stuff and have some unexplained problems, try something else as a test. I could be on the wrong track, but I don't think so. Good shooting, Tom [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Water soluble case lube problem
Top