Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Chatting and General Stuff
General Discussion
Using marine tex for bedding scope base?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="arthurj" data-source="post: 81350" data-attributes="member: 3718"><p>I really hope I just did this right! As it was only my second base to bed! I just finished bedding it an hour ago. I found which side fit best(which for me was the rear of the base) put on the epoxy, then barely snugged up the screws on the back. I just engaged the front screws, without any pressure on the base. </p><p></p><p>The first base I did seemed to fit much better, I couldn't figure which was best so I put on the epoxy then just engaged the screws, then laid a lapping bar in the rings with a small sand bag on it.</p></blockquote><p></p>
[QUOTE="arthurj, post: 81350, member: 3718"] I really hope I just did this right! As it was only my second base to bed! I just finished bedding it an hour ago. I found which side fit best(which for me was the rear of the base) put on the epoxy, then barely snugged up the screws on the back. I just engaged the front screws, without any pressure on the base. The first base I did seemed to fit much better, I couldn't figure which was best so I put on the epoxy then just engaged the screws, then laid a lapping bar in the rings with a small sand bag on it. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Chatting and General Stuff
General Discussion
Using marine tex for bedding scope base?
Top