Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
uncle b and goodgrouper help please loading equipment
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="goodgrouper" data-source="post: 139891" data-attributes="member: 2852"><p>I run a .001" oversized expander mandrel through the neck to get it to properly fit onto the turning mandrel. Then I take off the needed material in steps until the desired thickness is obtained. Then after firing the brass, it is wise to check the thickness again and if needed, make additional passes on the turner. But once the brass is fired, it is much harder to turn.</p><p></p><p>After being fired a few times, the brass will straighten itself out usually.</p></blockquote><p></p>
[QUOTE="goodgrouper, post: 139891, member: 2852"] I run a .001" oversized expander mandrel through the neck to get it to properly fit onto the turning mandrel. Then I take off the needed material in steps until the desired thickness is obtained. Then after firing the brass, it is wise to check the thickness again and if needed, make additional passes on the turner. But once the brass is fired, it is much harder to turn. After being fired a few times, the brass will straighten itself out usually. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
uncle b and goodgrouper help please loading equipment
Top