I have some stuff I have been collecting for a few months for a build, and I have decided to go a different route. So here is the list: A blued bolt for a 700 remington with a mag bolt face complete with firing pin, and it has the anti bind slotin the bottom lug $135 shipped the bolt does not appear to have been fired it is the style that is blued on both ends and the handle with natural steel in the middle no turning on the bolt body, the bolt face didn't have any brass on the blueing until I test fit a couple of cases to be sure it would fit the RUM cases. the Bolt is a non j lock shroud. the bolt handle has a couple of dings on the underside at the checkering on the knob, but it appears they were there before it was blued. 2 sets of rcbs 300 remington ultra mag dies both part #17601 in used but like new condition $25 shipped each set in box 1 set of 338 rcbs remington ultra mag dies part # 17701 in used but like new condition. $25 shipped The dies were bought from members on this site, and I only looked them over, and necked up a few 300 RUM to 338 to mock up some 338 edge rounds, and the locknuts were not even tightened on the set I used. I have 50 rounds of 300 RUM brass I bought it her in the classifieds as once fired, and it apperars to be once fired and I have no reason to doubt it. $35 shipped I have 40 rounds of 338 RUM brass I bought it her in the classifieds as once fired, and it apperars to be once fired and I have no reason to doubt it. $30 shipped The brass is all remington head stamps. I couldn't decide if I wanted a 300 RUM, 338 RUM, or a 338 EDGE, and figured I could make up my mind when I ordered the reamer and barrel, that is why I acquired all of this stuff. All prices firm, I will trade for berger 7mm 168 grain VLD hunting bullets, 280 AI nosler brass, and or Retumbo I have cash if you have more than this is worth. Other trades considered worst I can say is no.