elkaholic
Well-Known Member
Thats the 28 SM I mentioned.Is there a 28 Sherman magnum available?
Modified 300 PRC case. Dies, reamers, head stamped ADG brass all in stock.
Thats the 28 SM I mentioned.Is there a 28 Sherman magnum available?
That went right over my head until I just read the last post again , may be contacting you when my 28 nosler is burnt out. Sounds like a fun cartridge.Thats the 28 SM I mentioned.
Modified 300 PRC case. Dies, reamers, head stamped ADG brass all in stock.
That went right over my head until I just read the last post again , may be contacting you when my 28 nosler is burnt out. Sounds like a fun cartridge.
The SM reamer will clean up your chamber and probably get you up to 3200' if you wanted to run it hard. Should be good loads in the mid 3100'sRight now I am working on load development for my 7mm LRM and am getting 2960 with 195's and H-1000 with no signs yet of pressure. Might be able to squeeze a little more out of it with N570. The two cartridges above look intriguing though.
Here is a pic of the 28 and 30 SM
195 Berger at 3.720"
No I don't.Do you have a picture of the 28 SM next to the 28 N?
With Hornady brass? Man you must have gotten some good stuff. When I was shooting the lrm, I was shooting 180 hybrids at that speed to get brass to last, anything above 3k it was one and done.Right now I am working on load development for my 7mm LRM and am getting 2960 with 195's and H-1000 with no signs yet of pressure. Might be able to squeeze a little more out of it with N570. The two cartridges above look intriguing though.
I am not sure what manufacturer it is, I got the brass from them roughly 6 months ago. I hear they are now getting their brass from ADG. It still looks like the Hornady brass though as the weight of the brass is all over the place. I just started with this load so I will have to wait and see. I haven't seen any signs of issues yet but it is early in the process.With Hornady brass? Man you must have gotten some good stuff. When I was shooting the lrm, I was shooting 180 hybrids at that speed to get brass to last, anything above 3k it was one and done.
Keep us posted,,,interested...thanksI am not sure what manufacturer it is, I got the brass from them roughly 6 months ago. I hear they are now getting their brass from ADG. It still looks like the Hornady brass though as the weight of the brass is all over the place. I just started with this load so I will have to wait and see. I haven't seen any signs of issues yet but it is early in the process.