I apologize because I am sure this has been covered before, however after two days of searching the the forums I thought I would just ask .....
Have any of you had issue with the wet stainless pin tumbling causing problems with consistent ES or SD, "cold welding", etc.
Looking at previous posts, I saw a number of theories but no definitive conclusions. I am not really interested in pretty brass, mostly just accurate/consistent loads.
My theory is that clean cases would have a more consistent grip on the bullet than a dirty case. Clean is clean, but there are various degrees of dirty.
Thanks for any input.
Have any of you had issue with the wet stainless pin tumbling causing problems with consistent ES or SD, "cold welding", etc.
Looking at previous posts, I saw a number of theories but no definitive conclusions. I am not really interested in pretty brass, mostly just accurate/consistent loads.
My theory is that clean cases would have a more consistent grip on the bullet than a dirty case. Clean is clean, but there are various degrees of dirty.
Thanks for any input.