*SOLD PENDING FUNDS*
280ai
-Lone peak razor ti
-Proof sendero light 24" 8.44 tw
(Bbl installed/chambered/threaded by ao)
-Ti brake
(Sent it to steve pratt at elk meadow for brake)
-Mcmillan game hunter edge fill
-Hawkins bdl, Wyatt's extended box and follower. Hawkins hardware.
-Hawkins 30mm 25moa rings
-scope rail coated to match (not pictured)
-triggertech special
-custom cerakote work on everything, bedding, bodywork by me.
6lb 8oz as seen with rings, no scope or bipod included in sale.
$4400 shipped lower 48.
Has flush cups and studs. I haven't shot this much, have a group pictured to show where I left it last time I shot it with168vldh over retumbo. I remember it looked good with h4831sc as well. I was going to switch to 175ablr so I didn't work the load very hard but just haven't had time to shoot it. Hopefully I can find the charge weight for that group but either way it will need load development as I really did not spend much time with it at all. There is a lot of hand shaping work in this stock as you'll see in pics if you know these stocks. A lot of it you won't notice but you'll see the obvious around Floorplate and bolt handle. I don't like seeing the side of the Floorplate frame on round bottom stocks so I fixed it. I never planned to sell this one but it's sat out for two seasons already because I got too sidetracked to finish development so it's time for someone else to own it. I have a ton of pics of it, I'll post enough to get the point across. I can send or take more to actual interested parties. Please feel free to pm any questions and thanks for looking.
280ai
-Lone peak razor ti
-Proof sendero light 24" 8.44 tw
(Bbl installed/chambered/threaded by ao)
-Ti brake
(Sent it to steve pratt at elk meadow for brake)
-Mcmillan game hunter edge fill
-Hawkins bdl, Wyatt's extended box and follower. Hawkins hardware.
-Hawkins 30mm 25moa rings
-scope rail coated to match (not pictured)
-triggertech special
-custom cerakote work on everything, bedding, bodywork by me.
6lb 8oz as seen with rings, no scope or bipod included in sale.
$4400 shipped lower 48.
Has flush cups and studs. I haven't shot this much, have a group pictured to show where I left it last time I shot it with168vldh over retumbo. I remember it looked good with h4831sc as well. I was going to switch to 175ablr so I didn't work the load very hard but just haven't had time to shoot it. Hopefully I can find the charge weight for that group but either way it will need load development as I really did not spend much time with it at all. There is a lot of hand shaping work in this stock as you'll see in pics if you know these stocks. A lot of it you won't notice but you'll see the obvious around Floorplate and bolt handle. I don't like seeing the side of the Floorplate frame on round bottom stocks so I fixed it. I never planned to sell this one but it's sat out for two seasons already because I got too sidetracked to finish development so it's time for someone else to own it. I have a ton of pics of it, I'll post enough to get the point across. I can send or take more to actual interested parties. Please feel free to pm any questions and thanks for looking.
Last edited:
. All is well here, hope the same for you and your family. 
