Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Should I bed? B&C M40 with Al Block
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="jimbires" data-source="post: 1877537" data-attributes="member: 11011"><p>I bedded a bell and Carlson stock with the aluminum block . the rifle was previously bedded and the bedding material was cracking and falling out . I removed all the old bedding . I did use Ernie the gunsmith accurisers . these risers act like pillars when the job is done . my bedding block was counter sunk at the pillar a little , so I put a couple of the risers washers in to make this a little higher than the rest of the block . I bolted the action in place then took a note card and passed it between the action and stock to be sure there was no contact anywhere other than the accurisers . I put a couple layers of tape on the bottom of the recoil lug . then I bedded it with 10110 devcon . it turned out good and shoots good too .</p></blockquote><p></p>
[QUOTE="jimbires, post: 1877537, member: 11011"] I bedded a bell and Carlson stock with the aluminum block . the rifle was previously bedded and the bedding material was cracking and falling out . I removed all the old bedding . I did use Ernie the gunsmith accurisers . these risers act like pillars when the job is done . my bedding block was counter sunk at the pillar a little , so I put a couple of the risers washers in to make this a little higher than the rest of the block . I bolted the action in place then took a note card and passed it between the action and stock to be sure there was no contact anywhere other than the accurisers . I put a couple layers of tape on the bottom of the recoil lug . then I bedded it with 10110 devcon . it turned out good and shoots good too . [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Should I bed? B&C M40 with Al Block
Top