Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Reloading Newbie
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Rem700addict" data-source="post: 623429" data-attributes="member: 42574"><p>Hey guys i'm new to this forum and reloading in general, i've been reading the great info here and have been bit by the long range bug. I'm shooting a .243win Remington 700 97' model. I have aquired a reloading press and hornady dies from my uncle who used to reload some. So i'll get striaght to my question, i'm a machinist and have been using my calibers to measure the once fired casings from my rifle the COL is coming in at 2.034 plus or minus a thousanth. Everything else is very close to specs. So I set up my full length sizing die and gradually kept bumping it down not trying to push the shoulder back any. After sizing with the die my neck comes in at .238-.240 ID and .268-.270 OD and the OAL is moved to 2.040. I guess my concern is the neck is that going to be to tight to seat the bullet or does that seem right? I haven't purchased any loading materials yet, i'm just playing with the dies trying to learn to set them up. I'd appreciate any info you guys have as well as any good loads you guys might have for me to try. I think my barrell is the shorter barrell so I was thinking about going with a 95grn bullet, it will be a paper puncher/coyote/deer, i'm just trying to learn a little with this rifle before I start working on my .300wm Rem 700. Thanks guys.</p></blockquote><p></p>
[QUOTE="Rem700addict, post: 623429, member: 42574"] Hey guys i'm new to this forum and reloading in general, i've been reading the great info here and have been bit by the long range bug. I'm shooting a .243win Remington 700 97' model. I have aquired a reloading press and hornady dies from my uncle who used to reload some. So i'll get striaght to my question, i'm a machinist and have been using my calibers to measure the once fired casings from my rifle the COL is coming in at 2.034 plus or minus a thousanth. Everything else is very close to specs. So I set up my full length sizing die and gradually kept bumping it down not trying to push the shoulder back any. After sizing with the die my neck comes in at .238-.240 ID and .268-.270 OD and the OAL is moved to 2.040. I guess my concern is the neck is that going to be to tight to seat the bullet or does that seem right? I haven't purchased any loading materials yet, i'm just playing with the dies trying to learn to set them up. I'd appreciate any info you guys have as well as any good loads you guys might have for me to try. I think my barrell is the shorter barrell so I was thinking about going with a 95grn bullet, it will be a paper puncher/coyote/deer, i'm just trying to learn a little with this rifle before I start working on my .300wm Rem 700. Thanks guys. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Reloading Newbie
Top