Backcountry_IDN
Well-Known Member
So I did this project this year, shoots great. Could do better with a better shooter.
Tikka t3x action
Xcaliber 26inch threaded .264 1:7 6 groove
-had them do cryogenic treatment
Had a Smith put the barrel on, unfortunately he went with Winchester specs instead of Norma so oal of my round is 2.96. You can always ream it out for Norma. I was going to have him redo it but it shot so well and it was quite close to hunting season.
I have a LA magazine while the bolt stop is SA. I planned on seating out further until I realized it was winchester specs. Still cycles fine.
Also, I channeled out the barrel channel myself by hand using a hand sander and stone bit. As you can see from the grouping, it did not affect the accuracy.
-warne rings
-NF rail? I was told it was but cant find markings
-68 pieces of 1x fired LAPUA brass
-19 loaded rounds (I can pull bullets if needed)
- some unfired lapua brass
-100ish hornady eldx projectiles
-100 large rifle primers
-rcbs barely used dies
-load work done
-leupold vx5hd impact 29- few scratches since it was a hunting rifle. I wouldn't call them scratches but scuffs are a better term. Also, unused cds coupon.
-one small scratch on lense (see pic) unfortunately this just came to my attention. Didn't notice it during my rifle elk or mule deer hunt. Still cant notice when looking through but can see from afar.
Might be missing some. Only reason I'm selling is to upgrade my .300wm with a good optic.
I'll ship whole package for $1900obo
Or everything but leupold and rings for $1100
Tikka t3x action
Xcaliber 26inch threaded .264 1:7 6 groove
-had them do cryogenic treatment
Had a Smith put the barrel on, unfortunately he went with Winchester specs instead of Norma so oal of my round is 2.96. You can always ream it out for Norma. I was going to have him redo it but it shot so well and it was quite close to hunting season.
I have a LA magazine while the bolt stop is SA. I planned on seating out further until I realized it was winchester specs. Still cycles fine.
Also, I channeled out the barrel channel myself by hand using a hand sander and stone bit. As you can see from the grouping, it did not affect the accuracy.
-warne rings
-NF rail? I was told it was but cant find markings
-68 pieces of 1x fired LAPUA brass
-19 loaded rounds (I can pull bullets if needed)
- some unfired lapua brass
-100ish hornady eldx projectiles
-100 large rifle primers
-rcbs barely used dies
-load work done
-leupold vx5hd impact 29- few scratches since it was a hunting rifle. I wouldn't call them scratches but scuffs are a better term. Also, unused cds coupon.
-one small scratch on lense (see pic) unfortunately this just came to my attention. Didn't notice it during my rifle elk or mule deer hunt. Still cant notice when looking through but can see from afar.
Might be missing some. Only reason I'm selling is to upgrade my .300wm with a good optic.
I'll ship whole package for $1900obo
Or everything but leupold and rings for $1100
