pistol and rifle dies

Discussion in 'Reloading Equipment and Components' started by motrapper, Dec 5, 2007.

  1. motrapper

    motrapper Well-Known Member

    Messages:
    86
    Joined:
    Oct 14, 2007
    I have several Dillion and Redding and RCB dies that have been setting for afew years and now are tarnished or maybe its a slight rust is thier any way to clean or am i just out of luck.
    thanks
    sid
     
  2. redbone

    redbone Well-Known Member

    Messages:
    688
    Joined:
    Jul 3, 2005
    Motrapper

    Yuo can Clean them with MP7 ,
    You cam pick it up at your Gun Store .
    It will Clearn the rust off .
    Just put it on an let it set for 10 Miuntes then wipe the rust off .

    I use it on all of my Rifles .


    Redbone
     

  3. acloco

    acloco Well-Known Member

    Messages:
    502
    Joined:
    Jul 1, 2006
    Actually..you can soak them in a gallon can of carburetor cleaner. Costs about $10.

    Wash off with water, scrub a little, repeat if necessary.

    Will NOT harm the finish. Remove any rubber parts and dissassemble completely for a super clean job.
     
  4. motrapper

    motrapper Well-Known Member

    Messages:
    86
    Joined:
    Oct 14, 2007
    thanks for the replies gentlemen because i bet i have a thousand or more in dies alone just been out of it for afew years
    thanks again