Nightforce zero stop mod

30noslercam

Active Member
Joined
Apr 27, 2019
Messages
37
Location
New Zealand
I'm pretty sure I've read something along these lines here in the past. I recently acquired a nxs 3.5-15×50 with quick adjustments but no zero stop. I like the idea of threading the turret cap with a grub screw to create a zero stop. Is it really that simple? It will get hunted with aswel as gong shot and I prefer zero stops on all my scopes. Any advice welcome
 
You could try this. On the elevator shaft, use a threaded nut that has been drilled for a grub screw. set your zero, finger tighten the screw and then tighten the grub screw... Think of setting up a reloading die is how it might work.... Unsure as I don't have a scope like yours..
 
Another, slightly less invasive option. I have no experience with threading the turret cap, it may work better. This is just another idea if your worried about damaging something.
25066d1397878860t-new-zeiss-conquest-hd5-5-25x50-rifle-scope-siii-zero-stop.jpg
 
Warning! This thread is more than 6 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top