Nice grouping.

Discussion in 'Long Range Hunting & Shooting' started by robbobsam, Sep 24, 2011.

  1. robbobsam

    robbobsam Well-Known Member

    Messages:
    165
    Joined:
    Jun 15, 2010
    I would like to run something by you guys.

    I am currently running one of my .223ai's with 80 grain VLD's, I use it for long range varminting.

    I have done some load development with this rifle and am seating the 80 grain VLD's .005" into the lands at a COAL of 2.454", I am using 26.2 grains of varget and getting some interesting results.

    100m..........0.75" groups
    200m..........1.00" groups
    300m..........1.5" groups.

    [​IMG]

    It wasn't 300m as it states in the image above, when I actually ranged it from my shooting spot it was 319m (348yds).

    I got the elevation spot on but the windage was a couple of clicks out in the 10mph cross winds.

    I am getting 3050fps and the trajectory aligns itself perfectly with Nightforce Exbal which makes taking long shots in the field quite easy.

    The only thing that concerns me is that it is a warm load, the bolt is stiff when I unchamber a round after a shot, which isn't good, but I am reluctant to change the load as it seems to work so well. I did try other varget loads from 24-26.4grains but none of them performed at 200yds better than this one.

    Could you recommend an alternative powder/seating combination that may be worth trying to give me similar groups without the tight bolt (excessive pressure).

    The rifle has a 25.5" Kreiger barrel.
     
    Last edited: Sep 24, 2011
  2. WildRose

    WildRose Well-Known Member

    Messages:
    8,210
    Joined:
    Feb 3, 2011
    Try backing your seating off of the lans a little bit. That will reduce your chamber pressure and shouldn't blow your groups up.

    Are your primers starting to flatten out as well?
     

  3. robbobsam

    robbobsam Well-Known Member

    Messages:
    165
    Joined:
    Jun 15, 2010
    The primers are not flattened at all.