Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
neck turning
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="overbore" data-source="post: 171192" data-attributes="member: 2981"><p><strong>CAtShooter</strong></p><p></p><p>has it about right but has neglected to include total run out measurement in hi amplified and good response. If you get away from neck turning and accep the fact that there are "bananna shaped cases" out there, the quick mens to hunting accuracy is to measure the total runout of your loaded rounds and separate then into groups. Mark all of them on the head with an indelible marker and load all in the same position in your chamber every shot.. For example, load all the "marks" at 6 or 12 o'clock.</p><p></p><p>Use four broad runout groups.</p><p> I am primarily a benchrest shooter of the 300wsm and well familiar with and highly suggest the K&M Services, 717-292-3175, carbide fluted cuter to both turn and eliminate the dreaded donut simultaneously. I also use their expander so that we are using an apples to apples comparison starting with a round neck on the inside.</p><p></p><p>When you run a cartridge case through a sizing die, the brass has only one way to go which is toward the neck ( length ) which is why we must trim after checking with a good case length gage. If the neck is baove th egage length, trim it. </p><p></p><p>When you are ready to move up, I use Redding dies with a bushing for seating. Check out their web and have a look at Accurate Reloading and Benchrest Central. Best wishes, Overbore</p></blockquote><p></p>
[QUOTE="overbore, post: 171192, member: 2981"] [b]CAtShooter[/b] has it about right but has neglected to include total run out measurement in hi amplified and good response. If you get away from neck turning and accep the fact that there are "bananna shaped cases" out there, the quick mens to hunting accuracy is to measure the total runout of your loaded rounds and separate then into groups. Mark all of them on the head with an indelible marker and load all in the same position in your chamber every shot.. For example, load all the "marks" at 6 or 12 o'clock. Use four broad runout groups. I am primarily a benchrest shooter of the 300wsm and well familiar with and highly suggest the K&M Services, 717-292-3175, carbide fluted cuter to both turn and eliminate the dreaded donut simultaneously. I also use their expander so that we are using an apples to apples comparison starting with a round neck on the inside. When you run a cartridge case through a sizing die, the brass has only one way to go which is toward the neck ( length ) which is why we must trim after checking with a good case length gage. If the neck is baove th egage length, trim it. When you are ready to move up, I use Redding dies with a bushing for seating. Check out their web and have a look at Accurate Reloading and Benchrest Central. Best wishes, Overbore [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
neck turning
Top