Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck turning ?'s
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="tlk" data-source="post: 437656" data-attributes="member: 11397"><p>OK so I have a question: my new laupua brass (30-06) will not fit on the mandrel of my Forster turner - the brass is WAY too tight. I have the right mandrel/shaft on the turner, so where to now if I am to do the turning before shooting? The only thing I can see is to run it through a die with an expander ball or something, but I wonder if that would cause more problems that it would solve.</p><p> </p><p>Out of curiosity I used my Lee collet die as a pin guage as the decapper is .3055 - this brass is tighter than this as it is an issue to get it to feed into the case mouth. It takes a little force.</p><p> </p><p>The turner mandrel is .306 OD, confirmed. I have tried case lube, Kroil and Imperial wax, all to no avail - the brass will stop and stick right about the cutter.</p><p> </p><p>Advice?</p></blockquote><p></p>
[QUOTE="tlk, post: 437656, member: 11397"] OK so I have a question: my new laupua brass (30-06) will not fit on the mandrel of my Forster turner - the brass is WAY too tight. I have the right mandrel/shaft on the turner, so where to now if I am to do the turning before shooting? The only thing I can see is to run it through a die with an expander ball or something, but I wonder if that would cause more problems that it would solve. Out of curiosity I used my Lee collet die as a pin guage as the decapper is .3055 - this brass is tighter than this as it is an issue to get it to feed into the case mouth. It takes a little force. The turner mandrel is .306 OD, confirmed. I have tried case lube, Kroil and Imperial wax, all to no avail - the brass will stop and stick right about the cutter. Advice? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck turning ?'s
Top