Brent
Well-Known Member
Can one size the neck 3/4 the way down the neck on a fireformed case so the base of the neck centers the case in the chamber even though the chamber is factory?
Chamber is .346"
Loaded round is .337"
Bushing is .334"
I finally got my sizer die (Redding S) and figured I could tighen groups up some, but wondered if anyone's done this on a factory chamber before with success?
I read the Wilson bushings only size 40% of the neck and it got me thinking. I figured .75"-.100" of neck above the shoulder would give me enough to center the case up good and still leave plenty of support for the bullet. Any thoughts?
Chamber is .346"
Loaded round is .337"
Bushing is .334"
I finally got my sizer die (Redding S) and figured I could tighen groups up some, but wondered if anyone's done this on a factory chamber before with success?
I read the Wilson bushings only size 40% of the neck and it got me thinking. I figured .75"-.100" of neck above the shoulder would give me enough to center the case up good and still leave plenty of support for the bullet. Any thoughts?