Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck Bushing Sizes
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Roninco" data-source="post: 1897173" data-attributes="member: 114195"><p>I had a similar issue with my first Redding Bushing Die. After the third firing the bullet would fall through the neck. Eventually discovered the nut on the decapping rod was too high and the bushing was floating too high in the die and not contacting the neck. I was not using the decapping pin at the time. Screw the entire stem down until it contacts the bushing then back it off just a bit so the bushing will float.</p></blockquote><p></p>
[QUOTE="Roninco, post: 1897173, member: 114195"] I had a similar issue with my first Redding Bushing Die. After the third firing the bullet would fall through the neck. Eventually discovered the nut on the decapping rod was too high and the bushing was floating too high in the die and not contacting the neck. I was not using the decapping pin at the time. Screw the entire stem down until it contacts the bushing then back it off just a bit so the bushing will float. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Neck Bushing Sizes
Top