Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Measuring for Bullet Jump Question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Greg Duerr" data-source="post: 1278691" data-attributes="member: 32685"><p>I have a re-barreled 6.5 Creedmoor and was using the Hornady Modified case to check for COAL or to find out how far out to seat the bullet to touch the Lands. I noticed that I would hit a little resistance and had to apply just a little pressure for the Bullet to hit the lands. If the bore was not clean you could not push the Bullet at all not until the Riifle was cleaned pretty good with a bronze brush. Afterwards there was always a little noticeable resistance and with a little more pressure you could feel the bullet travel to the Lands .....................Whats going on is this normal??</p></blockquote><p></p>
[QUOTE="Greg Duerr, post: 1278691, member: 32685"] I have a re-barreled 6.5 Creedmoor and was using the Hornady Modified case to check for COAL or to find out how far out to seat the bullet to touch the Lands. I noticed that I would hit a little resistance and had to apply just a little pressure for the Bullet to hit the lands. If the bore was not clean you could not push the Bullet at all not until the Riifle was cleaned pretty good with a bronze brush. Afterwards there was always a little noticeable resistance and with a little more pressure you could feel the bullet travel to the Lands .....................Whats going on is this normal?? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Measuring for Bullet Jump Question
Top