Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
made my own bore guide. want feedback
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="dulzura" data-source="post: 638099" data-attributes="member: 44361"><p>I could not find exactly what I was looking for regarding a cleaning rod bore guide for my yet to be fired TC Venture 7mm Rem Mag. I was going to copy the ones made by Sinclair/Possum Hollow which are made of Delrin. When I punched the "buy" button for the Delrin stock and 12" drill bit from an online supplier, my dang wireless went down! I went out to my home workshop, chucked up some nylon stock and started turning. I had some SS tubing in the right diameter and came up with the following. The only thing I wondered was whether I should trim the case neck down so the brush/patches passed over the edge where the case ends or leave it like it is. My decision was to leave it. I made it so that it locks into the gun via the bolt release catch so I don't have to hold it in. Please let me know if you have any opinion on this design whether good/bad. Thanks.</p></blockquote><p></p>
[QUOTE="dulzura, post: 638099, member: 44361"] I could not find exactly what I was looking for regarding a cleaning rod bore guide for my yet to be fired TC Venture 7mm Rem Mag. I was going to copy the ones made by Sinclair/Possum Hollow which are made of Delrin. When I punched the "buy" button for the Delrin stock and 12" drill bit from an online supplier, my dang wireless went down! I went out to my home workshop, chucked up some nylon stock and started turning. I had some SS tubing in the right diameter and came up with the following. The only thing I wondered was whether I should trim the case neck down so the brush/patches passed over the edge where the case ends or leave it like it is. My decision was to leave it. I made it so that it locks into the gun via the bolt release catch so I don't have to hold it in. Please let me know if you have any opinion on this design whether good/bad. Thanks. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
made my own bore guide. want feedback
Top