Long Range Tactical 6.5 Creedmoor for Sale

Discussion in 'Guns For Sale' started by FishPermitonthefly, Mar 29, 2012.

  1. FishPermitonthefly

    FishPermitonthefly Member

    Messages:
    18
    Joined:
    Mar 21, 2012
    Hate to sell. Custom 6.5 Creedmoor, tight but no turn neck (0.293), Lilja 3 groove barrel with 1:8 twist cut and crowned at 24.75 inches. Terry Cross (McMillan) Sentinel stock with loggerhead cheekpeice adjust, Terry Cross bottom metal to accommodate AICS 10 round and 5 round clips. TAC 30 SS Stiller action blueprinted with Holland recoil lug and Badger aftermarket bolt knob. Jewell trigger set at 14 oz fully adjustable. Front mount for nightvision. Comes with Nightforce NXS 8x32 NPR-2 with Zero Stop, 20 MOA Stiller Mount and Badger Ordinance Rings. I will throw in both a 10 and 5 Round AICS clip.

    I have 26 rounds down the tube for breaking in purposes only. I have not shot groups with it though my friend build the identical rifle at the same time with all same parts etc (chamber reamer, same builder etc on same day) and it shoots 0.197 at 100 yards with 130 grain Berger bullets at 2,850 using IMR 4350. The build was completed in February 2012 but Nightforce Scope was off the rifle until Late March 2012 waiting for Zero Stop technology to be installed. I will not shoot it again. Need to sell for Medical Equipment in Medical School. Barrel cleans like a dream. No copper after 4-5 patches. Cannot shoot stock Hornaday ammo. Reamer accommodates shorter OAL by .0040. This allows for longer throat as barrel wears (to chase lands) providing longer shoot-able life.

    Asking 6,800 with buyer paying shipping.
     

    Attached Files:

  2. overbo

    overbo Well-Known Member

    Messages:
    81
    Joined:
    Feb 4, 2012
    Total weight of combo???? and do you have dies?
     

  3. FishPermitonthefly

    FishPermitonthefly Member

    Messages:
    18
    Joined:
    Mar 21, 2012
    Sorry. Because my buddy and I had duplicate rifles and he is not selling his, he has the dies. We were using a Redding full size bushing die with .289 bushing and a Wilson seater. No special dies needed here... I can give you the overall length for seating if needed. Weighs right in at 15.25 lbs.