Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Loads safe to shoot?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="arrow" data-source="post: 774976" data-attributes="member: 9798"><p>Well I got my redding uniformer and did the rest of the Norma brass. I was amazed at how much material had to be removed. And yes I'm keeping the cutter straight. I don't have a depth mic to measure but I went back to look at the problem cases and it was only a couple out of 60 that weren't cut deep enough. You can barely feel a bump when you run your finger over it. From a side view they can barely be seen. So should be good to fire and then just recut all those primer pockets? Also how long does it normally take to cut a primer pocket uniform with a drill at low power? I have always used cheaper brass and it went pretty quick. This is my first time with premium brass and it takes about a full minute for the cutter to bottom out with medium pressure. How much pressure should be used?</p></blockquote><p></p>
[QUOTE="arrow, post: 774976, member: 9798"] Well I got my redding uniformer and did the rest of the Norma brass. I was amazed at how much material had to be removed. And yes I'm keeping the cutter straight. I don't have a depth mic to measure but I went back to look at the problem cases and it was only a couple out of 60 that weren't cut deep enough. You can barely feel a bump when you run your finger over it. From a side view they can barely be seen. So should be good to fire and then just recut all those primer pockets? Also how long does it normally take to cut a primer pocket uniform with a drill at low power? I have always used cheaper brass and it went pretty quick. This is my first time with premium brass and it takes about a full minute for the cutter to bottom out with medium pressure. How much pressure should be used? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Loads safe to shoot?
Top