Lapua Brass / 6.5 Creedmoor

Obie458

Member
Joined
Feb 23, 2018
Messages
8
Location
Ny
My 6.5 CM redding S die set came with the smaller pin. Get the smaller pins -- I think they will hold fine. Internet says you can hone down the pins too. I worked down the pin on my Lee Decapping Die so that I could use it with my Lapua 6.5 CM with small primers and small flash hole...... Chucked the Lee decap pin in my drill press, used a piece of emory cloth and just went at it for a while. Seems to have worked....
 
Warning! This thread is more than 7 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.

Recent Posts

Top