Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Jewell Trigger Fitment Issues: Remington 700 SPS Varmint
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="whitely" data-source="post: 404289" data-attributes="member: 5167"><p>I've had to take the dremel to all the stocks that I have with jewel triggers. The safety on the outside of the trigger binds against the bottom ledge on the stock. You have to mill down about 3-4 mm along that ledge in most cases. I generally only remove enough to make it work, and then add a little for clearance. Just take out the trigger guard, and look from where the trigger protrudes. Mark the inside of the stock with a pen, and then dremel a little, etc. Might as well practice on that plastic stock.</p></blockquote><p></p>
[QUOTE="whitely, post: 404289, member: 5167"] I've had to take the dremel to all the stocks that I have with jewel triggers. The safety on the outside of the trigger binds against the bottom ledge on the stock. You have to mill down about 3-4 mm along that ledge in most cases. I generally only remove enough to make it work, and then add a little for clearance. Just take out the trigger guard, and look from where the trigger protrudes. Mark the inside of the stock with a pen, and then dremel a little, etc. Might as well practice on that plastic stock. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Jewell Trigger Fitment Issues: Remington 700 SPS Varmint
Top