Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Hunting
Long Range Hunting & Shooting
high buck brass vs cheaper
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Dirtrax" data-source="post: 2992604" data-attributes="member: 78945"><p>Winchester brass is fairly tough, but annealing is necessary to prevent neck splits. ADG has been good but again when pushed annealing is needed to maintain long life in my experience. I have so far used Alpha in one chambering. I have not had a single issue so far. I can't seem to wear it out. This is in a 6mm creedmoor that has had multiple reloads in everything from hot (hunting) to milder loads (PRS). </p><p>I will say that with quality brass one must be careful about reading signs of pressure. By the time the case shows it you are probably running on the edge.</p></blockquote><p></p>
[QUOTE="Dirtrax, post: 2992604, member: 78945"] Winchester brass is fairly tough, but annealing is necessary to prevent neck splits. ADG has been good but again when pushed annealing is needed to maintain long life in my experience. I have so far used Alpha in one chambering. I have not had a single issue so far. I can’t seem to wear it out. This is in a 6mm creedmoor that has had multiple reloads in everything from hot (hunting) to milder loads (PRS). I will say that with quality brass one must be careful about reading signs of pressure. By the time the case shows it you are probably running on the edge. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Hunting
Long Range Hunting & Shooting
high buck brass vs cheaper
Top