Grip n puller

I have a hammer puller, it works good . It just gets the powder everywhere. Thank you!

Your welcome. Read once about taking a small piece of foam rubber or the like and putting it in the bottom of the hammer where the powder and bullet fall. I tried it and it worked pretty well. Stopped me from messing up the point on some plastic tipped bullets. But if you don't crimp and are setting the bullets a little long where the grip-n-pull can get a good grip on the bearing surface of the bullets, it is the fastest bullet puller I have used.
 
Warning! This thread is more than 10 years ago old.
It's likely that no further discussion is required, in which case we recommend starting a new thread. If however you feel your response is required you can still do so.
Top