Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Flush Cup Install - Odd placement, OK?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="trucraft" data-source="post: 820982" data-attributes="member: 67624"><p>You could make a hole in the stock pack (bottom right) with a soldering iron or red hot 4" nail. This should seal the nylon edges if not just pick up some eyelets and crimp one over the hole. Then you can put it back on the stock and mark the location of the flush cup. </p><p>I'm sure I read a goood thread on The Hide regarding fitting flush cups.</p></blockquote><p></p>
[QUOTE="trucraft, post: 820982, member: 67624"] You could make a hole in the stock pack (bottom right) with a soldering iron or red hot 4" nail. This should seal the nylon edges if not just pick up some eyelets and crimp one over the hole. Then you can put it back on the stock and mark the location of the flush cup. I'm sure I read a goood thread on The Hide regarding fitting flush cups. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Gunsmithing
Flush Cup Install - Odd placement, OK?
Top