General RE LEE Well-Known Member Joined Aug 21, 2020 Messages 1,406 Location Middle Tennessee Jan 24, 2022 #1 Spinner bait arm. Works perfect Attachments 451907F1-5FF3-4C56-9F51-351A5EC10EAB.jpeg 1.5 MB · Views: 46
S Stammster Well-Known Member Joined May 22, 2020 Messages 699 Location Houston, Texas Jan 25, 2022 #2 That's a good idea. I'll these years I've used a paper clip that needs re-bent all the time.
L longbarrelxp Active Member Joined Jan 23, 2022 Messages 44 Location Henderson, NV Jan 25, 2022 #3 I use a piece of soft steel wire that I bend a 90 degree angle near one end, and cut off with dykes to get a sharp edge.
I use a piece of soft steel wire that I bend a 90 degree angle near one end, and cut off with dykes to get a sharp edge.
General RE LEE Well-Known Member Joined Aug 21, 2020 Messages 1,406 Location Middle Tennessee Jan 25, 2022 #4 This is ready to go. All I needed to do was slightly bend the loop at the end where the spinner is locked on the arm and snip the other end.
This is ready to go. All I needed to do was slightly bend the loop at the end where the spinner is locked on the arm and snip the other end.