Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Administration
Member Introductions
Custom fitting a case to a factory chamber
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Alaskan338Lapua" data-source="post: 287237" data-attributes="member: 18159"><p>My question is how would one go about fitting brass to a factory cut chamber. The rifle in question is a factory 300 WSM. I have tried necking down 300 Rem. Ultra mag brass since they are based of the same parent case, the .404 Jeffery and have had less than admirable results. Anyone have any ideas?</p></blockquote><p></p>
[QUOTE="Alaskan338Lapua, post: 287237, member: 18159"] My question is how would one go about fitting brass to a factory cut chamber. The rifle in question is a factory 300 WSM. I have tried necking down 300 Rem. Ultra mag brass since they are based of the same parent case, the .404 Jeffery and have had less than admirable results. Anyone have any ideas? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Administration
Member Introductions
Custom fitting a case to a factory chamber
Top