Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
case annealing
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="kc0pph" data-source="post: 550225" data-attributes="member: 35934"><p>I use a Torch with MAPP Gas. Set all of the brass in a pan with water up to the point i aneal. I usually go just below the neck. I make them glow cherry red then push them over in the water using the torch. I find that propane does not get them hot enough as a lot of heat is transfered to the water. I have found i use a lot less gas if i put lead weights inside the case and leave the spent primers in it. This makes it go much faster as there is no water inside of the case. My cases are not too awful stable if there is no weight and i just set them in the water.</p></blockquote><p></p>
[QUOTE="kc0pph, post: 550225, member: 35934"] I use a Torch with MAPP Gas. Set all of the brass in a pan with water up to the point i aneal. I usually go just below the neck. I make them glow cherry red then push them over in the water using the torch. I find that propane does not get them hot enough as a lot of heat is transfered to the water. I have found i use a lot less gas if i put lead weights inside the case and leave the spent primers in it. This makes it go much faster as there is no water inside of the case. My cases are not too awful stable if there is no weight and i just set them in the water. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
case annealing
Top