Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Can I trim cases with my drill press?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="BigJakeJ1s" data-source="post: 414896" data-attributes="member: 12889"><p>Perhaps the quickest way to trim brass on a drill press is to chuck the Lee cutter/gauge in the drill press, and move the table so that the gauge pin does not fall into a hole, but stops on the table. Then just hold the deprimed brass down on the table with a leather glove, and lower the spinning cutter/gauge into it. No fumbling with case holders or anything else.</p><p></p><p>Andy</p></blockquote><p></p>
[QUOTE="BigJakeJ1s, post: 414896, member: 12889"] Perhaps the quickest way to trim brass on a drill press is to chuck the Lee cutter/gauge in the drill press, and move the table so that the gauge pin does not fall into a hole, but stops on the table. Then just hold the deprimed brass down on the table with a leather glove, and lower the spinning cutter/gauge into it. No fumbling with case holders or anything else. Andy [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
Can I trim cases with my drill press?
Top