Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Advice needed
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="LB" data-source="post: 35910" data-attributes="member: 2721"><p>It absence of factory instructions....I'd be sure and work the barreled action into the stock evenly until you are sure it is bottomed out. Then tighten the front screw TIGHT. The rear tang should not be torqued. After snugging, and after the front recoil lug is tight, no more than half to three quarters of a turn, additional. If I had to guess, five to ten pounds? There may be a number of better plans out there, but that's how I do it.</p><p></p><p>Good hunting. LB</p></blockquote><p></p>
[QUOTE="LB, post: 35910, member: 2721"] It absence of factory instructions....I'd be sure and work the barreled action into the stock evenly until you are sure it is bottomed out. Then tighten the front screw TIGHT. The rear tang should not be torqued. After snugging, and after the front recoil lug is tight, no more than half to three quarters of a turn, additional. If I had to guess, five to ten pounds? There may be a number of better plans out there, but that's how I do it. Good hunting. LB [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
Advice needed
Top