Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
7mm Rem Mag bullets pushing deep into the case with recoil
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Coyboy" data-source="post: 100854" data-attributes="member: 3733"><p>KDL, after sizing, measure your outside neck dia. After seating a bullet, measure it again. The Dia. should have increased by .001-.002" This is the amount of grip the brass has on the bullet. If it's under .oo1, you can do what Dan said about polishing the expander ball. Your brass may have thin neck walls measure them also should be around .015". If they are thin the size die will not work with that brass because the outside dia. would have to be smaller to get the inside dia. small enough to grip the bullet.</p></blockquote><p></p>
[QUOTE="Coyboy, post: 100854, member: 3733"] KDL, after sizing, measure your outside neck dia. After seating a bullet, measure it again. The Dia. should have increased by .001-.002" This is the amount of grip the brass has on the bullet. If it's under .oo1, you can do what Dan said about polishing the expander ball. Your brass may have thin neck walls measure them also should be around .015". If they are thin the size die will not work with that brass because the outside dia. would have to be smaller to get the inside dia. small enough to grip the bullet. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
7mm Rem Mag bullets pushing deep into the case with recoil
Top