DoneNOut
Well-Known Member
Sent a barrel in to have chambered for 7mm-08AI. They said I could send them a 7mm-08AI go gauge, or they would just use a 7-08 go gauge + .004. What do you think?
Ok, That is what I was thinking. I will just buy a gauge and send it. My 243AI gauge from Forster worked great in my rifle.The Go gauge actually becomes the NO GO gauge.....better clarify that. The AI is actually Shorter than the parent case so it would be Go minus .004. I like Minus .006 to minus .010, and on the minus .010 I run new brass through the full length sizer and bump back. New brass will vary a little on the headspace length.
I'll be daggum. The bodies are the same aren't they. BALD moment here! LOL ThanksWould not the 243AI go gauge work?
I'm not doing it. A shop is. I'll send them the gauges. LOLEASY BUTTON!! Use your desired NEW brass and set a .004".005" "crush" on full bolt close .. DONE!
PO set the chambers up to be able to be done exactly this way..