Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
6.5 WSSM Dies??
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="RockZ" data-source="post: 145078" data-attributes="member: 5750"><p>I have decided to rebarrel my 243WSSM to a 6.5/25WSSM.</p><p>Now I need to figure out the best way to load for it. I had a couple of ideas. </p><p>I am planning on using the sinclair expander mandrel to neck up from 25 to 6.5. Then:</p><p>1. Forster Ultra micrometer seater and full length sizing die set in 25wssm and send it to Forster to open up to the proper diameter and put in a .264 expander.</p><p></p><p>2.Redding Type-S full length sizing die in 25 wssm and getting the proper bushing.</p><p></p><p>What size bushing do I need or what diameter should I specify?</p><p>What diameter would work best to open up the seating die to?</p><p>Chamber is a .303 neck, so I figure a loaded round should be .300 o.d. at the neck. Would .297 bushing do it for the sizer?</p></blockquote><p></p>
[QUOTE="RockZ, post: 145078, member: 5750"] I have decided to rebarrel my 243WSSM to a 6.5/25WSSM. Now I need to figure out the best way to load for it. I had a couple of ideas. I am planning on using the sinclair expander mandrel to neck up from 25 to 6.5. Then: 1. Forster Ultra micrometer seater and full length sizing die set in 25wssm and send it to Forster to open up to the proper diameter and put in a .264 expander. 2.Redding Type-S full length sizing die in 25 wssm and getting the proper bushing. What size bushing do I need or what diameter should I specify? What diameter would work best to open up the seating die to? Chamber is a .303 neck, so I figure a loaded round should be .300 o.d. at the neck. Would .297 bushing do it for the sizer? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
6.5 WSSM Dies??
Top