Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Hunting
Extreme Long Range Hunting & Shooting (ELR)
338NM action??
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Fiftydriver" data-source="post: 892021" data-attributes="member: 10"><p>I am not sure if you can get the bolt face you need WITHOUT the .750" bolt body diameter. Remember though, that as the bolt body diameter increases so does the bore hole size in the receiver, your trading steel for steel so weight difference will not be dramatic between a 0.750" bolt and a 0.700" bolt.</p><p> </p><p> Again, not sure if Defiance will offer this bolt face diameter with a standard diameter bolt, you would have to check if that's what you want. </p><p> </p><p> One more note however, the Defiance receiver has a hell for stout bolt handle design. On a Rem 700 inletted stock, the bolt notch will need to be opened up slightly to the rear of the notch to allow this very strong bolt handle to clear the stock. Easy to do with a steady hand and a dremel tool with a 1/2" drum sander attached.</p><p> </p><p> There may also need some extending of the ejection port but that will likely be the case with ANY custom receiver out there. Good luck with your project.</p></blockquote><p></p>
[QUOTE="Fiftydriver, post: 892021, member: 10"] I am not sure if you can get the bolt face you need WITHOUT the .750" bolt body diameter. Remember though, that as the bolt body diameter increases so does the bore hole size in the receiver, your trading steel for steel so weight difference will not be dramatic between a 0.750" bolt and a 0.700" bolt. Again, not sure if Defiance will offer this bolt face diameter with a standard diameter bolt, you would have to check if that's what you want. One more note however, the Defiance receiver has a hell for stout bolt handle design. On a Rem 700 inletted stock, the bolt notch will need to be opened up slightly to the rear of the notch to allow this very strong bolt handle to clear the stock. Easy to do with a steady hand and a dremel tool with a 1/2" drum sander attached. There may also need some extending of the ejection port but that will likely be the case with ANY custom receiver out there. Good luck with your project. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Hunting
Extreme Long Range Hunting & Shooting (ELR)
338NM action??
Top