Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Reloading
338 lapua dies work in 338 lapua-imp
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="seidersjoden" data-source="post: 1881564" data-attributes="member: 56644"><p>I have a related issue to your comment. I have a 338 Lapua AI 40 degree shoulder. I'm shoulder bumping the cases that have been fired twice that are fitting kind of snug. I'm using all Redding dies, neck sizer, seater and a body die.</p><p></p><p>My issue is the body die doesn't bump the shoulder back no matter how deep I screw it in. Even if I screw it in where I can't push the handle of the rock chuck all the way through its full cycle. These are not custom dies but The guys in the custom shop at Reading looked at my reamer print and said these version one dies should work for my 40° shoulder angle based off the print dimension. I got a few weeks before I leave on a bear hunt so this is getting down to the wire. Anyone have any input?</p></blockquote><p></p>
[QUOTE="seidersjoden, post: 1881564, member: 56644"] I have a related issue to your comment. I have a 338 Lapua AI 40 degree shoulder. I’m shoulder bumping the cases that have been fired twice that are fitting kind of snug. I’m using all Redding dies, neck sizer, seater and a body die. My issue is the body die doesn’t bump the shoulder back no matter how deep I screw it in. Even if I screw it in where I can’t push the handle of the rock chuck all the way through its full cycle. These are not custom dies but The guys in the custom shop at Reading looked at my reamer print and said these version one dies should work for my 40° shoulder angle based off the print dimension. I got a few weeks before I leave on a bear hunt so this is getting down to the wire. Anyone have any input? [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Reloading
338 lapua dies work in 338 lapua-imp
Top