Forums
New posts
Search forums
What's new
Articles
Latest reviews
Author list
Classifieds
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
338 EDGE Brass. Nosler or Remmy?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="LongBomber" data-source="post: 450553" data-attributes="member: 14435"><p>I have used both, and I have both an edge and a 300rum. Guys talk about how the Nosler brass is soft, but I get several loadings from them. I don't try and push the book max in the 300, as my accuracy load is a half grain under book max (200gr accubond). I normally try for a load with the smallest vertical spread not just the highest velocity. Now I stick to Rem brass in my 300 and Nosler in my edge. </p><p> </p><p>I weighed cases for consistency but I did not check Nosler vs Rem. The Noslers were all within a half grain per box of 50 (I have 3 boxes, likely enough to wear out the barrel with). The remingtons went up to 2 grains difference.</p><p> </p><p>In Nosler brass I have pushed the berger hybrid with loads from 90-95gr of H-1000 with no primer pocket issues, however I ran into the bullet slump issue at 94.5gr. I run 92gr of H-1000 behind the hybrid and have 5 loadings on one set of brass.</p></blockquote><p></p>
[QUOTE="LongBomber, post: 450553, member: 14435"] I have used both, and I have both an edge and a 300rum. Guys talk about how the Nosler brass is soft, but I get several loadings from them. I don't try and push the book max in the 300, as my accuracy load is a half grain under book max (200gr accubond). I normally try for a load with the smallest vertical spread not just the highest velocity. Now I stick to Rem brass in my 300 and Nosler in my edge. I weighed cases for consistency but I did not check Nosler vs Rem. The Noslers were all within a half grain per box of 50 (I have 3 boxes, likely enough to wear out the barrel with). The remingtons went up to 2 grains difference. In Nosler brass I have pushed the berger hybrid with loads from 90-95gr of H-1000 with no primer pocket issues, however I ran into the bullet slump issue at 94.5gr. I run 92gr of H-1000 behind the hybrid and have 5 loadings on one set of brass. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rifles, Reloading, Optics, Equipment
Rifles, Bullets, Barrels & Ballistics
338 EDGE Brass. Nosler or Remmy?
Top